ANTI-LOCK BRAKES – Chevrolet SSR 2006 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram for Chevrolet SSR 2006

List of elements for Anti-lock Brakes Wiring Diagram for Chevrolet SSR 2006:

• (on bottom left side of dash) data link connector (dlc)
• Abs fuse 38 60a
• Abs indicator
• Abs pump
• B10
• B12
• Body control module (bcm) (rear center of passenger compartment, near rear relay block)
• Brake fluid level switch (on brake master cylinder fluid reservoir)
• Brake fluid lvl sig
• Brake fuse 51 10a
• Brake indicator
• C11
• Center console switch assembly
• Cruise control system
• Delivered torque sig
• Delivered torque signal
• Electronic brake control module (ebcm) (left side of inner frame rail)
• Engine control module (ecm) (left front side of engine compt)
• G100 (lower left front of engine)
• G300 (base of left "b" pillar)
• G400 (on left front frame body mount)
• Hot at all times
• Hot in run
• Hot in run or start
• Hvac 1 fuse 39 10a
• Ign e fuse 23 10a
• Ignition 3
• Instrument panel cluster
• Ipc/dic fuse 24 10a
• Left front wheel speed sensor (on left front hub & bearing assembly)
• Lf whl spd sens ref
• Lf whl spd sens sig
• Logic
• Nca
• Pnk
• Rear fuse block (rear center of passenger compt)
• Red
• Requested torque sig
• Requested torque signal
• Rf whl spd sens ref
• Rf whl spd sens sig
• Right front wheel speed sensor (on right front hub & bearing assembly)
• S202
• S203
• Serial data
• Sp201 (below steering column, taped to harness)
• Stop lamp switch (top of brake pedal assembly)
• Tan
• Tcc brake switch sig
• Traction ctrl sw sig
• Traction disabled indicator
• Traction on/off switch
• Underhood fuse block (on left side of engine compt)
• Vehicle speed signal
• Vss