CRUISE CONTROL – Chevrolet Corvette Z06 2003 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Corvette Z06 2003

List of elements for Cruise Control Wiring Diagram for Chevrolet Corvette Z06 2003:

• Accelerator pedal position sensor (top of accelerator pedal)
• App 1 5v ref
• App 1 gnd
• App 1 sig
• App 2 5v ref
• App 2 gnd
• App 2 sig
• App 3 5v ref
• App 3 gnd
• App 3 sig
• Ccp sw sig
• Clutch pedal position switch (on top of clutch pedal bracket)
• Cr cont a
• Cruise control switch
• Eng ign 1 fuse 19 10a
• Exterior lights system
• Fuse 20 10a b
• Fuse 8 20a b
• G106 (right side of engine, above starter)
• Ground
• High front sig
• Hot at all times
• Hot in run or start
• Hot with ign relay energized (in run or start)
• I/p fuse block (in right front footwell)
• Ignition
• Low front sig
• M/t
• Multifunction turn signal lever
• Nca
• Off
• On/off sig
• Pnk
• Powertrain control module (right side of engine compt)
• R/a
• Res/acc sig
• S120
• S213
• Set/ coast
• Set/coast sig
• Stop sw sig
• Stoplamp switch (brake pedal support)
• Stp haz a
• Tac ctrl 1
• Tac ctrl 2
• Tac serl data
• Tan
• Tcc/cruise sw sig
• Throt cont fuse 17 15a
• Throttle actuator control module (attached to pcm, below battery)
• Throttle actuator control motor (left side of throttle body)
• Throttle position sensor (on right side of throttle body assembly)
• Tps 1 5v ref
• Tps 1 gnd
• Tps 1 sig
• Tps 2 5v ref
• Tps 2 gnd
• Tps 2 sig
• Underhood fuse block (right rear of engine compt)
• Vehicle speed sensor (top right side of differential)