NAVIGATION – Chevrolet Captiva Sport LTZ 2013 – SYSTEM WIRING DIAGRAMS

NAVIGATION

Parking Assistant Wiring Diagram for Chevrolet Captiva Sport LTZ 2013

List of elements for Parking Assistant Wiring Diagram for Chevrolet Captiva Sport LTZ 2013:

• (in rear bumper harness) j420
• (in rear bumper harness) j421
• B10
• Batt pos volt
• Computer data lines system
• G203 (near lower center of dash, on i/p fuse block)
• Ground
• Hot at all times
• Instrument panel fuse block
• Left middle rear object sensor (rear bumper fascia)
• Left outer rear object sensor (rear bumper fascia)
• Lo spd gmlan serial data
• Logistic mode fuse 10a
• Lr corner obj sens sig
• Lr middle object sens sig
• Obj sens low ref
• Obj sens sply volt
• Rear parking assist control module (under second row right seat on floor)
• Right middle rear object sensor (rear bumper fascia)
• Right outer rear object sensor (rear bumper fascia)
• Rr corner object sens sig
• Rr middle object sens sig
• X204
• X409

Rear View Camera Wiring Diagram for Chevrolet Captiva Sport LTZ 2013

List of elements for Rear View Camera Wiring Diagram for Chevrolet Captiva Sport LTZ 2013:

• (body harness, 31.7 cm from sdm connector breakout)
• Backup lp sply vol
• Bare
• Body control module (bcm) (front of center floor console)
• Camera sig (+)
• Camera sig (-)
• Exterior lights system
• G401 (under left side of luggage compt)
• Hot w/ run/ crank relay energized
• Inside rearview mirror (isrvm)
• Instrument panel fuse block
• Isrvm/rcm fuse 5a
• J307
• J901
• Logic
• Lt pnk
• Mirror display
• Nca camera sig + nca camera drain wire nca backup lp sply volt nca camera sig - nca gnd nca ign 1 volt
• Pnk
• Rearview camera (to left of license lamp)
• X400
• X900
• X912
• X925