STARTING/CHARGING – Chevrolet Malibu Classic LS 2008 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chevrolet Malibu Classic LS 2008

List of elements for Charging Wiring Diagram for Chevrolet Malibu Classic LS 2008:

• (ecm)
• 2.2l
• 3.5l
• Battery
• Charge indicator
• Computer data lines system
• Engine control module (ecm) (left side of engine compt, forward of battery)
• G104 (left side of engine compt)
• G105 (right rear of engine, on engine to transmission stud)
• Generator
• Generator field duty cycle signal
• Generator turn on signal
• High speed gmlan serial data bus +
• High speed gmlan serial data bus -
• Ign
• Instrument panel cluster (ipc)
• Low speed gmlan serial data
• Power distribution system
• Red
• Starter solenoid
• Tan

Starting Wiring Diagram for Chevrolet Malibu Classic LS 2008

List of elements for Starting Wiring Diagram for Chevrolet Malibu Classic LS 2008:

• (2.2l)
• (3.5l)
• (under front of center console) body control module (bcm)
• 2.2l
• 3.5l
• 5v ref
• Acc
• Battery
• C10
• Charging circuit
• Computer data lines system
• D12
• Engine control module (ecm) (left side of engine compt, forward of battery)
• G104 (left side of engine compt)
• G105 (right rear of engine, on engine to transmission stud)
• G109 (near windshield wiper fluid reservoir)
• High speed gmlan serial data bus +
• High speed gmlan serial data bus -
• Hot at all times
• Ign 1 vol
• Ign sensor fuse 2a
• Ignition switch
• Key-in ignition switch
• Logic
• Off
• Off/run crank voltage signal
• Park/neutral position (pnp) switch (3.5l: on top of transmission)
• Park/neutral signal
• Pnk
• Power distribution system
• Red
• Run
• Start
• Start relay 31
• Starter motor
• Starter rly coil ctrl
• Strtr fuse 26 30a
• Tan
• Underhood fuse block (on left side of engine compt)
• X1 e12
• X4 d1