SUPPLEMENTAL RESTRAINTS – Chevrolet Tracker 2001 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Chevrolet Tracker 2001

List of elements for Supplemental Restraint Wiring Diagram for Chevrolet Tracker 2001:

• (floor harness) s300
• (i/p harness) s250
• (not used)
• 1.6l & 2.0l
• 15a
• 2.5l
• A10
• A11
• A12
• A13
• A14
• A15
• A16
• A17
• A18
• Air bag fuse (in sir harness)
• Air bag indicator
• B1-b8
• C1-c8
• Data link connector (dlc) obd-ii (partial) (below left side of dash, right of steering column)
• Dr frnt high
• Dr frnt low
• G302 (under center console)
• Ground
• Hot in on & start
• Ig fuse 20a
• Ignition
• Ind ctrl
• Inflatable restraint i/p module
• Inflatable restraint sensing & diagnostic module (sdm) (below front of center console)
• Inflatable restraint steering wheel module
• Inflatable restraint steering wheel module coil
• Instrument cluster
• Junction block (in left kick panel)
• Left of steering column)
• Nca
• Near license plate lamps) g411
• Not used
• Note: shorting bar is used on inflatable restraint sensing & diagnostic module when disconnected from harness, between pins: a9-a18
• Pass fnt high
• Pass frnt lo
• Powertrain control module (pcm) (under right side of dash)
• S249 (i/p harness)
• S260 (i/p harness)
• Seat belt indicator
• Seat belt sw
• Seat belt switch (open w/seat belt buckled) (in seat belt buckle)
• Serial data
• Shorting bar
• Sir data link connector (behind dash,