ANTI-LOCK BRAKES – Chevrolet Impala 2000 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Chevrolet Impala 2000

List of elements for Anti-lock Brake Wiring Diagrams for Chevrolet Impala 2000:

• (base of left "b" pillar)
• (left side of brake pedal bracket)
• (right side of brake pedal bracket)
• A10
• A11
• A12
• Abs warning ind
• Abs/pcm fuse 10a
• B10
• B11
• Battery
• Body control module (behind left side of dash)
• Brake fluid level switch (in master cylinder reservoir)
• Brake ind
• Brake pressure modulator valve
• Brk sw fuse 15a
• C10
• C11
• Data link connector (dlc) (below left side of dash)
• Delivered torque
• Desired torque
• E12
• Electronic brake control module (ebcm) (in left rear of engine compartment)
• Electronic traction control switch
• G114 (lower left rear of engine, on transaxle stud)
• G202
• G202 (on left side of brake pedal bracket)
• G308
• Ground
• Hot at all times
• Hot in on or start
• Ignition
• Impala
• Instrument cluster
• Interior lights system
• Left front wheel spd (hi)
• Left front wheel spd (lo)
• Left front wheel speed sensor
• Left i/p accessory wiring junction block
• Left rear wheel spd (hi)
• Left rear wheel spd (lo)
• Left rear wheel speed sensor
• Low trac ind
• Monte carlo
• Nca
• Pnk
• Powertrain control module (in air cleaner box)
• Pump motor
• Red
• Right front wheel spd (hi)
• Right front wheel spd (lo)
• Right front wheel speed sensor
• Right i/p accessory wiring junction block
• Right rear wheel spd (hi)
• Right rear wheel spd (lo)
• Right rear wheel speed sensor
• S169
• S190
• S236
• S253
• S322
• S338
• Serial data signal
• Splice pack sp205 (taped to harn, next to left i/p accessory wiring junction block)
• Stop lamp sw out
• Stoplamp switch (brake pedal support)
• Tan
• Trac off ind
• Vent tube