CRUISE CONTROL
Cruise Control Wiring Diagram for Ford Explorer 1997
List of elements for Cruise Control Wiring Diagram for Ford Explorer 1997:
- A/t w/ high series console
- A/t w/o high series console
- Accel
- Back light
- Brake on/off (boo) switch (on brake pedal support)
- Brake press input
- Brake pressure switch (left rear corner of engine compt)
- C286
- C338
- Clutch pedal position (cpp) switch (on clutch pedal arm)
- Clutch pedal position (cpp) switch jumper (left side of i/p, taped to main harness)
- Coast
- Fuse 15a
- Fuse 7.5a
- G100 (left front of engine compt, near radiator)
- G104 (left rear corner of engine compartment, at fender apron)
- Ground
- Headlamp switch
- Horn relay (in power distri- bution box)
- Horn switches
- Hot at all times
- Hot in run
- Ignition
- Ignition cylinder tamper switch
- Indicator control
- Instrument cluster
- Interior fuse panel
- Interior lights system
- M/t
- Maxi fuse 11 20a
- Nca
- Off
- Ohms
- Power distribution box
- Remote anti-theft personality (rap) module (left rear quarter panel)
- Resume
- S113
- S134
- S156
- S157
- S168 (engine harn, near breakout to 4wabs control module)
- S212 (main harn, near breakout to data link conn)
- Set/
- Speed cont sw gnd
- Speed cont sw in
- Speed control indicator lamp
- Speed control servo/ amplifier assembly (right rear of engine compartment)
- Speed control/ horn switch assembly (in steering column assembly)
- Vehicle speed input
- Vehicle speed sensor (vss) (on transmission)