CRUISE CONTROL – Mitsubishi Galant SE 2010 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Mitsubishi Galant SE 2010

List of elements for Cruise Control Wiring Diagram for Mitsubishi Galant SE 2010:

• (behind instrument cluster) g6
• (behind instrument cluster) joint connector 2
• (in steering column) clock spring
• (main)
• (sub)
• (w/ mitsubishi multi- communication system (mmcs)) multi-center display unit
• A-13
• Abs/tcl-ecu (right rear corner of engine compt)
• Acc
• Accelerator pedal position sensor (above accelerator pedal)
• Auto-cruise control switch
• B-19
• B-20
• B-21
• B-22
• B-23
• C-211
• C-214
• C-29
• C-303
• C-306
• C-31
• Can
• Combination meter
• Computer data lines system
• Cpu
• Cruise ind
• Data link connector (under left side of dash)
• Engine controls system
• Fuse 10a
• Fuse 15a
• Fuse 20a
• Fuse 7.5a
• G11 (left front of engine compt)
• Hall ic
• Hot at all times
• Hot in on or start
• Ignition switch
• Joint connector 1 (upper left end of dash)
• Joint connector 3 (behind instrument cluster)
• Junction block (behind left side of dash)
• Lock
• Mfi relay (on engine compt relay box)
• Off
• On/off
• Output shaft speed sensor (on top of transaxle)
• Powertrain control module (left front of engine compt)
• Red
• Relay box (left side of engine compt)
• Relay box)
• Res
• Rheostat circuit
• Set
• Start
• Starting/ charging system
• Stoplight switch (attached to pedal support member)
• Throttle actuator control motor
• Throttle actuator control motor relay (on engine compt
• Throttle body assembly
• Transmission range switch (on top of transaxle)
• Transmissions system