CRUISE CONTROL
Cruise Control Wiring Diagram for Mitsubishi Raider SE 2007
List of elements for Cruise Control Wiring Diagram for Mitsubishi Raider SE 2007:
- (at right front of engine compartment) g103
- (near top of transmission) s122
- 3.7l
- 4.7l
- 5 speed
- A919
- Accel/ resume
- Accelerator pedal position sensor (3.7l) (under left side of dash)
- Apps rtn 1
- Apps rtn 2
- Apps sig 1
- Apps sig 2
- Can b bus (+)
- Can c bus (+)
- Cancel
- Clockspring (in steering column)
- Coast
- Computer data lines system
- D65
- Engine controls system
- Etc mtr (+)
- Etc mtr (-)
- F855
- F856
- Fuse 20a
- Fused b (+)
- Hot at all times
- Instrument cluster
- Integrated power module (at left side of engine compartment)
- K122
- K22
- K23
- K400
- K447
- K448
- K900
- K922
- K961
- Left speed control switch
- Nca
- On/ off
- Pnk/red
- Powertrain control module (at right side of engine compartment)
- Red
- Right speed control switch
- S/c brake switch output
- S/c sw 1 sig
- S/c sw return
- S/c vacuum solenoid ctrl
- S/c vent solenoid ctrl apps rtn 1
- S118 (near rear of engine)
- S124 (at top right of engine)
- S133
- Sens gnd
- Sensor ground
- Set
- Speed control servo (at right front of engine compartment)
- Stop lamp switch (behind lower left side of dash)
- Throttle body (3.7l) (top of engine)
- Throttle position sensor (4.7l) (on throttle body)
- Tp sens 1 sig
- Tp sens rtn
- Tp sensor 1 sig
- Tp sig 2
- V32
- V35
- V36
- V37
- V38
- V937
- Vacuum
- Vent