CRUISE CONTROL – Nissan Rogue SL 2014 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Rogue SL 2014

List of elements for Cruise Control Wiring Diagram for Nissan Rogue SL 2014:

• (top of brake pedal assy) stop lamp switch
• (top of steering column) spiral cable
• (under left headlight assy)
• 16r
• 38j
• 41j
• 50j
• Accel/res switch
• Accelerator pedal position sensor (top of accelerator pedal assembly)
• Acsd steering switch
• Aps1
• Aps2
• Ascdsw
• Avcc-tps
• Bncsw
• Brake pedal position switch (top of brake pedal assy)
• Can-h
• Can-l
• Cancel
• Coast/ set
• Combination meter
• Computer data lines system
• E15
• E152
• E16
• E28
• Ecm (left front of engine compt)
• Ecm relay
• Ecm relay (self shut off)
• Electric throttle control actuator
• F33 e19
• F35
• F42
• F51
• F52
• Fuse 10a
• Fuse 36 15a
• Fuse block (j/b) (left end of dash)
• Gnda-aps1
• Gnda-aps2
• Gnda-ascdsw
• Gnda-tps
• Hot at all times
• Hot in acc or on
• Hot in on or start
• Ipdm e/r (intelligent power distribution module engine room) (left side of engine compt)
• J/c e01 (left end of dash)
• J/c m18 (lower center of dash)
• M30
• M31
• M31 e152
• M68
• M90
• Main switch
• Pnk
• Pnp sig
• Red
• Sens pwr sply
• Sensor 1
• Sensor 2
• Shield
• Starting/charging system
• Stop lp sw
• Switch
• Tan
• Tcm (transmission control module) (left rear of engine compt)
• Throttle control motor
• Throttle control motor relay
• Throttle position sensor
• Transmission range switch (top left side of transmission)
• Unified meter control unit
• Vehcan-h
• Vehcan-l