ANTI-LOCK BRAKES
Anti-lock Brake Wiring Diagrams for Ford Explorer 1995
List of elements for Anti-lock Brake Wiring Diagrams for Ford Explorer 1995:
- 4wabs control module (left rear corner of engine compartment)
- 4wabs hydraulic unit (left side of engine compartment)
- 4wabs main relay
- 4wabs pump motor (left side of engine compt)
- 4wabs pump relay
- Abs diode
- Acceleration sensor (left frame rail, under driver seat)
- Anti-lock brakes indicator
- Auxiliary relay box #1
- Brake on/off (boo) switch (on brake pedal support)
- Brake on/off sw feed
- Data link connector (behind left side of i/p)
- Dump valve
- Exterior lights system
- Fuse 10a
- Fuse 15a
- Fuse 30a
- G-switch #1
- G-switch status
- G104 (left rear corner of engine compt, at fender apron)
- G108 (left front of engine compartment, near radiator)
- Gem iso link
- Generic electronic module (gem) (behind center of i/p)
- Ground
- Hot at all times
- Hot in run
- Hot in run or start
- Ignition
- Instrument cluster
- Interior fuse panel
- Iso valve
- L fnt dump valve
- L fnt iso valve
- L fnt sensor (hi)
- L fnt sensor (lo)
- Left front
- Left front wheel 4wabs sensor
- Motor speed sens #2
- Nca
- Pnk
- Power distribution box
- Powertrain control module (at right kick panel)
- Pump motor rly coil (-) g-switch #2
- Rear
- Rear axle sensor
- Rear dump valve
- Rear iso valve
- Rear sensor (hi)
- Rear sensor (lo)
- Red/pnk
- Relay coil (-)
- Right front
- Right front wheel 4wabs sensor
- Rt fnt dump valve
- Rt fnt iso valve
- Rt fnt sensor (hi)
- Rt fnt sensor (lo)
- Tan
- Tan/ red
- Tan/red
- Vehicle power
- Warning lamp