CRUISE CONTROL – Ford Explorer Sport Trac 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Explorer Sport Trac 2005

List of elements for Cruise Control Wiring Diagram for Ford Explorer Sport Trac 2005:

• (if equipped)
• Air bag sliding contact (on steering column)
• Battery junction box (bjb) (left side of engine compartment, at fender apron)
• Brake pedal position switch (above brake pedal)
• Brake press input
• Brake pressure switch (on brake master cylinder)
• C218a
• C220a
• C220b
• C281b
• Central junction box (cjb) (behind left side of dash)
• Coast
• Four-wheel drive control module (at right kick panel)
• Fuse 2a
• Fuse 7.5a
• G105 (at right side of engine compartment)
• G204 (at left kick panel)
• G300 (at left kick panel)
• Ground
• Horn
• Horns system
• Hot at all times
• Hot in run
• Indicator control
• Instrument cluster
• Interior lights system
• Micro- processor
• Off
• Output shaft speed (oss) sensor (on rear of transmission)
• Overhead console
• Powertrain control module (pcm) (mounted through firewall)
• Red/
• Rest
• Resume
• S116 (in dash panel to headlamp junction wiring harness, near breakout at left center side of engine compartment)
• S117 (in dash panel to headlamp junction wiring harness, near breakout at left center side of engine compt)
• S127
• S143 (in engine control sensor & fuel charge wiring harness, near breakout to g100)
• S206
• S213 (in main wiring harness, near breakout to c215)
• S214
• S216
• S218
• Set/ acc
• Speed cont sw gnd
• Speed cont sw in
• Speed control actuator (in right rear of engine compartment)
• Speed control indicator
• Steering wheel/ speed control switch
• Vehicle speed input
• Vpwr
• Vss
• Windshield wiper motor (left of center, at rear of engine compt)