STARTING/CHARGING – Chevrolet Cobalt 2005 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chevrolet Cobalt 2005

List of elements for Charging Wiring Diagram for Chevrolet Cobalt 2005:

• 2.0l
• 2.2l
• 5 volt ref
• Battery
• Battery indicator
• Body control module (bcm) (under center console, below radio)
• Body control module (bcm) (under center of dash, below radio)
• Computer data lines system
• Current sensor low ref
• Current sensor sig
• Engine control module (ecm) or powertrain control module (pcm) (left side of engine compartment)
• G203 (left of steering column)
• G403 (in rear compt of vehicle, near battery current sensor)
• Gen f-term
• Gen l-term
• Generator
• Gmlan ecm
• Gnd
• Hi speed gmlan serial data +
• Hi speed gmlan serial data -
• Hot in run or start
• I/p ign fuse 10a
• Ign
• Instrument panel cluster (ipc)
• Lo spd gmlan serial data
• Logic
• Pnk
• Power distribution system
• Red
• Starter
• Tan

Starting Wiring Diagram for Chevrolet Cobalt 2005

List of elements for Starting Wiring Diagram for Chevrolet Cobalt 2005:

• 2.0l
• 2.2l
• 5v ref
• A10
• Acc
• Armature
• B10
• B12
• Back up fuse 10a
• Battery
• Body control module (bcm) (under center of dash)
• Charging circuit
• Clutch start switch (under left side of dash, attached to clutch pedal bracket)
• Computer data lines system
• Crank fuse 30a
• Crank relay
• Engine control module (ecm) or powertrain control module (pcm) (left side of engine compartment)
• G403 (in rear compt of vehicle, near battery current sensor)
• Hi speed gmlan serial data +
• Hi speed gmlan serial data -
• Hold-in windings
• Hot in acc or run
• I/p ign fuse 10a
• Ignition switch
• Lock
• Logic
• M/t
• Off
• Off/run/crank voltage
• Park/neutral position (pnp) switch (on top of transmission)
• Pnk
• Pnp/clutch start switch signal
• Power distribution system
• Pull-in windings
• Red
• Run
• Run/ crank relay
• Start
• Starter
• Starter relay coil control
• Tan
• Underhood fuse block (in engine compartment, next to left strut tower)