ELECTRONIC SUSPENSION – Isuzu Ascender S 2008 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram for Isuzu Ascender S 2008

List of elements for Electronic Suspension Wiring Diagram for Isuzu Ascender S 2008:

• 4wd fuse 15a
• Air suspension compressor (behind right rear wheelwell)
• B11
• Bat pos volt
• Ecas fuse 30a
• Engine control module (ecm) (near lower left front of engine)
• G305 (on outside of left frame rail, near fuel tank)
• Ground
• Hot at all times
• Hot in run
• Ign 3 volt
• Ind ctrl
• Inflator air switch (on right side of cargo area, on trim panel)
• Instrument panel cluster
• J117 (in i/p harness, 8.5 cm from x100 breakout)
• J306
• Left rear air suspension sensor (on frame rail, near left rear suspension arm)
• On/off
• Radio (premium)
• Rear fuse block (below left rear seat)
• Red
• Right rear air suspension sensor (on frame rail, near right rear suspension arm)
• Sensor ret
• Sensor sig
• Speed sens
• Sw sig
• Tan
• Transmissions system
• Underhood fuse block (above left front wheelwell)
• Vss