WIPER/WASHER – Jaguar XK8 1997 – SYSTEM WIRING DIAGRAMS

WIPER/WASHER

Wiper/Washer Wiring Diagram for Jaguar XK8 1997

List of elements for Wiper/Washer Wiring Diagram for Jaguar XK8 1997:

• (engine compartment, forward of left hand hood catch) g104
• (engine compartment, forward of left hand hood catch) g104
• (i) acc
• (ii) run
• (left hand "a" post) g202
• (not used)
• (right hand headlamp) g107
• Body processor module (passenger side fascia, on airbag bracket)
• Column switch gear
• Delay
• Dip
• Driver side fuse box (driver side fascia)
• Engine compartment fuse box (left front of engine compartment)
• Fast
• Fast wipe
• Fc14
• Fc5
• Fc6
• Flick wipe
• Fluid level
• Fuse 3 30a
• Fuse 5 15a
• Fuse 7 15a
• Fuse 7 30a
• Hot at all times
• Ignition nca switch
• Input
• Intermittent wipe
• Left brake booster enclosure relays (left rear corner of engine compartment)
• Lf6
• Lighting stalk
• Logic gnd
• Note: early production vehicles with vin numbers below (vin 003300) use connector pin numbrers, which differ from volume production numbers shown. use wire color code for pin identification on early production models.
• Off
• Off (0)
• Ohms
• Output
• Park switch
• Power gnd
• Power wash pump (left front fender)
• Power wash relay (no.4)
• Red
• Sc1
• Sc2
• Side
• Slow
• Slow wipe
• Start (iii)
• Wash
• Wash/wipe stalk
• Windshield wash pump & fluid level sensor (left front fender)
• Wiper fast/ slow relay
• Wiper motor (base of windshield, behind air intake plenum)
• Wiper run/ stop relay