INTERIOR LIGHTS
Interior Lights Wiring Diagram for Chrysler Sebring Touring 2009
List of elements for Interior Lights Wiring Diagram for Chrysler Sebring Touring 2009:
- (at left kick panel) g302
- (at right "a" pillar) s342
- (at right "a" pillar) s343
- (at right kick panel) g306
- (behind left end of dash) s204
- (center floor, right of tunnel) g300
- (near base of left "b" pillar) g301
- Analog clock module
- Automatic a/c
- B(+)
- Bank switch
- Base
- C11
- Can b bus (+)
- Can b bus (-)
- Can bus (+)
- Can bus (-)
- Cargo lamp
- Cluster
- Computer data lines system
- Courtesy lamps drv
- Cup holder assembly (except base)
- D506
- Decklid ajar sw sns
- Decklid door latch (at center rear of deck lid)
- Dimmer/light switch
- Dome lamp
- Driver door latch (rear of left front door)
- E12
- Electronics
- Except base
- Front passenger door latch (rear of right front door)
- Fuse 10a
- Fused b(+) (i.o.d.)
- G200 (at left end of dash)
- G306 (at right kick panel)
- Ground
- Hazard switch
- Hot at all times
- Ign sw out (run-start)
- Left rear door latch (rear of left rear door)
- Left vanity lamp
- Lf door ajar sw sns
- Lin bus
- Lr door ajar sw sns
- Manual a/c
- Map 1 lamp
- Map 2 lamp
- Map lamp
- Panel lamps drv
- Pnk/ f202
- Prndl lamp
- Reading/rail lamps drv
- Rf door ajar sw sns
- Right rear door latch (rear of right rear door)
- Right vanity lamp
- Rr door ajar sw sns
- S205
- S222
- S260 (near breakout to instrument cluster)
- S339
- S349
- S349 (automatic a/c)
- S353
- S359
- Steering control module (on steering column)
- Totally integrated power module (left side of engine compt)
- Ugdo enable ctrl
- Z910