ANTI-LOCK BRAKES – Dodge Dakota 1996 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

All-Wheel ABS Wiring Diagram for Dodge Dakota 1996

List of elements for All-Wheel ABS Wiring Diagram for Dodge Dakota 1996:

• (right i/p)
• 4-wheel drive input
• A20
• Abs control module (left fender side shield)
• Abs power relay (in power distribution center)
• Abs warning ind
• Abs warning ind check
• Abs warning ind relay
• Abs warning lamp relay (in power distribution center)
• Acc
• B113
• B114
• B116
• B120
• B18
• B19
• B243
• B245
• B248
• B249
• B252
• B254
• B47
• B60
• Brake ind
• Brake sense
• Brake warning ind
• Brake warning lamp switch (in hydraulic unit)
• C118
• C119
• C221
• Case ground
• Cluster
• D11
• D12
• Data link connector (left side of steering column)
• Data link input
• Data link output
• Dump sol
• Four wheel drive indicator switch (on transfer case)
• Front hydraulic valve (on left front fender shield)
• Fuse 5a
• Fuse a 40a
• Fuse block
• G100 (left fender side shield)
• G102 (left fender side shield)
• G107
• G19
• G201
• G206 (left of radio)
• Hot at all times
• Hot in run
• Ignition feed
• Ignition switch
• Instrument
• Instrument cluster
• Instrument cluster system (4wd ind lamp in shift bezel)
• Isolate sol
• Left dump and isolation solenoids
• Left front reset
• Left front sensor high
• Left front sensor low
• Left front wheel sensor
• Lt frnt dump valve ctrl
• Lt ft isolate valve ctrl
• Motor
• Motor feedback
• Off
• Park brake switch (on park brake)
• Power distribution center
• Power ground
• Power relay enable
• Pump motor return
• Rear dump valve ctrl
• Rear hydraulic valve (near master cylinder)
• Rear isolate valve ctrl
• Rear reset
• Rear sensor high
• Rear sensor low
• Rear wheel speed sensor (top of rear differential)
• Red
• Reset sw
• Reset switches
• Right dump and isolation solenoids
• Right front reset
• Right front sensor high
• Right front sensor low
• Right front wheel sensor
• Rt frnt dump valve ctrl
• Rt ft isolate valve ctrl
• Run
• Start
• Stop lamp switch (on brake pedal bracket)
• To engine controls system
• V40

Rear Wheel ABS Wiring Diagram for Dodge Dakota 1996

List of elements for Rear Wheel ABS Wiring Diagram for Dodge Dakota 1996:

• (a/t)
• (m/t)
• 4-wheel drive input
• Abs warning ind
• Abs warning ind ctrl
• Acc
• B101
• B102
• B108
• B111
• B112
• B113
• B114
• Battery
• Brake sw input
• Brake warning lamp switch (on left frame rail)
• Bulb check
• C221
• C24
• Combination buzzer
• Data link connector (left side of steering column)
• Diode (taped in i/p harness)
• Dump sol
• Dump valve sol
• Exterior lights system (center mounted stop lamp)
• Exterior lights system (hazard flasher switch)
• F32
• Four wheel drive indicator switch (on transfer case)
• Fuse 10a
• Fuse 20a
• Fuse block
• G11
• G201 (right end of i/p)
• G201 (right i/p)
• G206 (left of radio)
• Ground
• Hot at all times
• Hot in run or start
• Ignition
• Ignition switch
• Instrument cluster
• Instrument cluster system (4wd ind lamp in shift bezel)
• Intermittent wiper control unit (under steering column)
• Isolate sol
• K29
• Off
• Park brake ind
• Park brake input
• Park brake switch (on park brake)
• Powertrain control module (right front fender apron)
• Rear isolate valve sol
• Rear wheel anti-lock control module (right kick panel)
• Rear wheel anti-lock sensor (top of rear axle)
• Reset
• Reset sw
• Run
• Rwal sensor
• Rwal valve (near master cylinder)
• Service data link
• Start
• Stop lamp switch (on brake pedal bracket)