ANTI-LOCK BRAKES – Jeep Wrangler Sahara 2001 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Jeep Wrangler Sahara 2001

List of elements for Anti-lock Brake Wiring Diagrams for Jeep Wrangler Sahara 2001:

• A10
• A20
• Abs relay control
• Abs warning ind
• Anti-lock brake relay (in power distribution center)
• B10
• B41
• B42
• B43
• Battery
• Brake lamp switch (top of brake pedal arm)
• C27 sci transmit c3
• Controller anti-lock brake (at left rear corner of eng compt)
• D21
• Data link connector (bottom left side of dash)
• Exterior lights
• F15
• Fuse 10a
• Fuse 20a
• Fuse 30a
• Fuse 40a
• Fuse block (under right side of dahs)
• Fused ign (run)
• G sw sensor 1
• G sw sensor 2
• G sw test signal
• G switch (in front console/shifter, mounted to bracket on floor pan)
• G121 (center rear of eng compt)
• G83
• Ground
• Hot at all times
• Hot in run
• Hot in run & start
• Instrument cluster
• L50
• Left front wheel speed sensor
• Left rear wheel speed sensor
• Lf wheel spd sens +
• Lf wheel spd sens -
• Lr wheel spd sens +
• Lr wheel spd sens -
• Pnk
• Power (battery)
• Power distribution center (right side of engine compt, on inner fender panel)
• Powertrain control module (right rear of eng compt, on firewall)
• Red
• Rf wheel spd sens +
• Rf wheel spd sens -
• Right front wheel speed sensor
• Right rear wheel speed sensor
• Rr wheel spd sens +
• Rr wheel spd sens -
• S106
• S108 (eng harn, near breakout for pdc)
• Sci transmit
• Stoplight sw out
• Z22