CRUISE CONTROL – Jeep Wrangler SE 2003 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Jeep Wrangler SE 2003

List of elements for Cruise Control Wiring Diagram for Jeep Wrangler SE 2003:

• (2.4l)
• (4.0l)
• (behind center rear of instrument panel) s215
• (between engine starter solenoid & c182)
• (bottom left end of dash) datalink connector
• (canada)
• (near breakout for ignition coil pack)
• (near breakout to underhood light, on center of firewall)
• (on left side of firewall) s106
• +5v
• Accel resume/
• Brake lamp switch (0n bracket, above brake pedal)
• Brake sw
• Brake switch sense
• Brake transmission shift interlock solenoid (left side of steering column)
• Breakout to c202,c203 &c204) s209
• Cancel
• Clock- spring
• Coast
• Cruise control ind
• D25
• Daytime running lamp module (in rear of engine compt, on firewall)
• Dump
• Fuse 10a
• Fuse block (under right center of dash)
• Fused ignition
• G100 (on left center of firewall)
• G300 (left kick panel)
• Ground
• Hot in run or start
• Instrument cluster
• K29
• Left speed control switch
• Nca
• On/off
• Pci bus
• Powertrain control module (in right rear of engine compt, on firewall)
• Right speed control switch
• S123
• S127 (near breakout to idle air control motor)
• S133
• S135
• S147
• S163 (between g101 and right front wheel speed sensor)
• Sensor gnd
• Set
• Signal
• Speed control servo (left side of engine compt)
• Speed sw sig
• Tan/red
• V32
• V35
• V36
• V37
• Vacuum
• Vacuum sol
• Vehicle speed sensor (on extension housing of transfer case)
• Vent
• Vent sol
• Vss input