CRUISE CONTROL – Jeep Wrangler Unlimited X 2009 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Jeep Wrangler Unlimited X 2009

List of elements for Cruise Control Wiring Diagram for Jeep Wrangler Unlimited X 2009:

• (left side of dash) g202
• (right side of engine compartment) g103
• 5v sply
• 87a
• Accelerator pedal position sensor (base of accelerator pedal)
• App sig 1
• App sig 2
• App sns gnd 1
• App sns gnd 2
• B (+)
• B15
• B16
• Brake lmp sw
• Brake sig 1
• Brake sig 2
• Can c bus (+)
• Can c bus (-)
• Clutch interlock switch (m/t) (rear of engine compartment)
• Clutch sig
• Computer data lines system
• D64
• D65
• Electronics
• Engine controls system
• Etc motor (+)
• Etc motor (-)
• Exterior lights system
• F855
• F856
• Fuse m1 20a
• Fuse m37 10a
• Gnd
• Hot at all times
• Input spd sig
• Input speed sensor (left side of transmission)
• K122
• K124
• K126
• K167
• K22
• K23
• K29
• K400
• K922
• L51
• Output spd sig
• Output speed sensor (left side of transmission)
• Pnk
• Powertrain control module (left side of engine compartment)
• Rly ctrl
• Run/ start relay
• S/c rtn
• S/c sig 1
• S/c sig 2
• S128 (in engine harness)
• S132 (in engine harness)
• S137 (in engine harness)
• S251
• S273 (right side of dash, near speaker breakout)
• S299
• Snsr gnd
• Speed control switch
• Steering control module
• Stop lamp switch (base of brake pedal)
• T13
• T14
• T141
• T52
• Throttle body (top of engine)
• Totally integrated power module (right side of engine compartment)
• Tp sig 1
• Tp sig 2
• Tp snsr gnd
• Transmissions system
• V71
• V72
• V937