WARNING SYSTEMS – Cadillac XLR 2006 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Cadillac XLR 2006

List of elements for Warning Systems Wiring Diagram for Cadillac XLR 2006:

• 4.6l 4.4l
• Ajar
• Audible alarm
• Auto
• Bcm class 2 serial data
• Bcm high spd gmlan serial data bus +
• Bcm high spd gmlan serial data bus -
• Body control module (bcm) (behind right side of dash)
• C1 a5
• Class 2 (rcdlr)
• Class 2 (sdm)
• Closed
• Computer data lines system
• Driver door latch
• Ecm high spd gmlan serial data bus +
• Ecm high spd gmlan serial data bus -
• Engine control module (ecm) (behind lower right front fender)
• G201
• G301
• Head
• Inflatable restraint sensing & diagnostic module (sdm) (located underneath vehicle console)
• Instrument panel cluster (ipc)
• Internal antenna
• Ipc
• Ipc class 2 serial data
• Left front tire pressure monitor sensor
• Left rear tire pressure monitor sensor
• Left seat belt sw
• Left seat belt switch
• Lf dr open sw sig
• Lf turn sig sw
• Logic
• Low ref
• Low tire pressure ind
• Message center
• Message request
• Nca
• Off
• Open
• Park
• Pk lmp sw on sig
• Pnk
• Remote control door lock receiver (rcdlr) (right side of dash)
• Rf turn sig sw
• Rfa class 2 serial data
• Right front tire pressure monitor sensor
• Right rear tire pressure monitor sensor
• S275
• S375
• S391 (instrument panel harness, approximately 11.0 cm from yaw rate connector)
• Sdm class 2 serial data
• Seat belt ind
• Solid state
• Sp201 (in instrument panel harness, at base of left a pillar behind trim panel, grounded to g201)
• Sp301 (in instrument panel harness, on left "b" pillar behind trim panel, grounded to g301)
• Tan
• Turn signal/ multifunction switch