CRUISE CONTROL – GMC Safari 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for GMC Safari 2005

List of elements for Cruise Control Wiring Diagram for GMC Safari 2005:

• (on left rear of engine, next to knock sensor) g106
• A12
• A13
• A14
• A15
• Anti-lock brakes system
• Brake fuse 18 10a
• C201
• Cruise control module (center front of firewall, near windshield wiper module)
• Cruise control on/off switch
• Cruise engaged
• Cruise fuse 6 10a
• Cruise on/off input
• Exterior lights system
• G105 (on thermostat housing)
• Ground
• Hot at all times
• Hot in run
• I/p fuse block (behind left side of dash)
• Ignition
• Instrument cluster system
• Multifunction turn signal lever
• Off
• Pnk
• Powertrain control module (pcm) (below underhood fuse block, on left side of firewall)
• R/a
• Resume/accel input
• S/c
• S117
• S127
• S130 (in i/p harness, 32 cm from i/p fuse block breakout)
• S200 (in i/p harness, 16 cm from i/p fuse block)
• S201
• S204
• S333 (in engine harness, 15 cm from vehicle speed sensor)
• Set/coast input
• Stop/haz fuse 1 20a
• Stoplamp sw input
• Stoplamp switch (shown brakes off) (above brake pedal)
• Tcc brake sw input
• Vehicle speed sensor (vss) (on rear of transmission)
• Vss high
• Vss low
• Vss signal