ANTI-LOCK BRAKES – Saab 9-7X Linear 2005 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram for Saab 9-7X Linear 2005

List of elements for Anti-lock Brakes Wiring Diagram for Saab 9-7X Linear 2005:

• (on bottom left side of dash) data link connector (dlc)
• 4.2l
• 5.3l
• A10
• Abs fuse 33 60a
• Abs pump
• Anti-lock brake indicator
• B10
• Body control module (bcm) (beneath left rear seat, on rear fuse block)
• Brake fluid level switch (on brake master cylinder fluid reservoir)
• Brake fuse 52 10a
• Brake indicator
• C11
• Cruise control system
• Electronic brake control module (ebcm) (on inner left frame rail, beside transmission)
• G107 (on lower left side of engine)
• G304 (on outside of left frame rail, near electronic brake control module)
• Hot at all times
• Hot in run
• Hot in run or start
• Ign 3
• Ign e fuse 22 10a
• Instrument panel cluster
• Ipc/dic fuse 24 10a
• Left front wheel speed sensor (on left front spindle/hub assembly)
• Lf sens low ref
• Lf sens sig
• Lvl sens sig
• Nca
• Pnk
• Powertrain control module (pcm) (4.2l) engine control module (ecm) (5.3l) (4.2l: on upper left side of engine) (5.3l: near lower left front of engine)
• Rear fuse block (below left rear seat)
• Red
• Rf sen low ref
• Rf sens sig
• Right front wheel speed sensor (on right front spindle/hub assembly)
• Serial data
• Sp205 (behind left of dash, near headlamp switch connector)
• Stop lamp switch (on brake pedal assembly)
• Tan
• Tcc brake sw
• Underhood fuse block (on left side of engine compt)
• Vehicle speed signal
• Vss