CRUISE CONTROL – Mitsubishi Endeavor LS 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Mitsubishi Endeavor LS 2008

List of elements for Cruise Control Wiring Diagram for Mitsubishi Endeavor LS 2008:

• (at right rear corner of engine compartment) asc/tcl ecu
• (behind instrument cluster) joint connector 2
• (in steering column) clock spring
• (main)
• (sub)
• Acc
• Accelerator pedal position sensor (above accelerator pedal)
• Auto-cruise control switch
• B-18
• B-19
• B-20
• B-21
• B-22
• C211
• C214
• C303
• C306
• Can
• Combination meter
• Computer data lines system
• Cpu
• Cruise ind
• Engine compartment relay box (left side of engine compt)
• Engine controls system
• Fuse 11 15a
• Fuse 7.5a
• Fuse 9 20a
• G12 (left front of engine compartment)
• Hall ic
• Hot at all times
• Hot in on or start
• Ignition switch
• Joint connector 1 (behind instrument cluster)
• Joint connector 4 (behind instrument cluster)
• Junction block (left end of dash)
• Lock
• Main
• Mfi relay (on engine compt relay box)
• Off
• Output shaft speed sensor (on top of transaxle)
• Powertrain control module (left front of engine compartment)
• Red
• Res
• Rheostat circuit
• Set
• Start
• Starting/ charging system
• Stoplight switch (under left side of dash)
• Throttle actuator control motor
• Throttle actuator control motor relay (on engine compt relay box)
• Throttle body assembly (top rear of engine)
• Throttle position sensor
• Transmission range switch (on top of transaxle)
• Transmissions system