CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Quest SL 2011
List of elements for Cruise Control Wiring Diagram for Nissan Quest SL 2011:
- Accelerator pedal position sensor (behind left side of dash)
- Acsd steering switch
- Aps1
- Aps1 avcc1
- Aps1 gnda
- Aps2
- Aps2 avcc2
- Aps2 gnda
- Ascd brake switch (behind left side of dash)
- Ascdsw
- Ascdsw gnda
- Bncsw
- Brake
- Can-h
- Can-l
- Cancel
- Close
- Combination meter
- Combination switch (spiral cable)
- Computer data lines system
- Cruise ind
- Cvt unit
- E10
- E103
- E105
- E16
- E21 (rear of engine)
- E38 (rear of engine)
- Ecm (front left side of engine)
- Electric throttle control actuator (right rear of engine compt)
- F12
- Fuse 10a
- Fuse 51 15a
- Fuse block j/b (behind left side of dash)
- Gnd
- Hot at all times
- Hot w/ ignition relay energized
- Ipdm e/r (intelligent power distribution module engine room) (left side of engine compt)
- M11
- M303
- M33
- Main (on/off)
- Motor 1
- Motor 2
- Motrly
- Nca
- Open
- Pnk
- Pri spd sens
- Primary speed sensor
- Red
- Resume/ accelerate
- Sec spd sens
- Secondary speed sensor
- Sens gnd
- Sens pwr
- Sensor 1
- Sensor 2
- Set/ coast
- Stop lamp relay
- Stop lamp switch
- Tcm (transmission control module) (left front of engine compt)
- Throttle control motor
- Throttle control motor relay
- Throttle position sensor
- Tps avcc1
- Tps gnda
- Tps1
- Tps2
- Vbr
- Veh can-h
- Veh can-l
- Vmot