TRANSMISSION
Transmission Wiring Diagram for Mitsubishi Eclipse GS 1993
List of elements for Transmission Wiring Diagram for Mitsubishi Eclipse GS 1993:
- (behind left side of i/p)
- (j/b pin #2 (taillight relay))
- 1995 vftc c
- 4-speed automatic transaxle control module (behind center of i/p)
- 4-speed automatic transaxle solenoid valve
- A/c rly sig
- A/t fluid temperature sensor (on valve body)
- A/t temp ind (dome light) (awd turbo)
- Accel sw
- Accelerator pedal switch (behind i/p)
- Auto cruise ctrl unit pin #1
- Auto-cruise
- Auto-cruise ctrl
- Auto-cruise ctrl pin # 10
- Back-up lights
- Battery back-up (j/b pin #2)
- Closed throttle position switch
- Cluster
- Cruise
- Ctps
- Ctrl unit
- Data link conn
- Data link conn pin #11
- Dlc mode ctrl
- Dlc output
- Dual pressure
- Econ
- Fuse #18 (j/b)
- Fuse #7 (j/b)
- G200 (left kick panel)
- G201 (behind right side of dash)
- G206 (below center of i/p)
- G206 (right center i/p support)
- Gnd
- Ign pulse
- Ign system
- Ignition switch
- Inst cluster
- Instrument
- Jumper connector (26 pin partial w/ optional wiring harness)
- Kick-dn sw
- Kick-down servo switch (on transaxle)
- Mfi control mod pin 18
- Mfi control module
- Mfi control module pin 19
- Mfi control module pin 6
- Nca
- Non turbo
- Non-turbo
- O/d sw
- Off
- Oil pressure control solenoid valve
- Oil temp lt
- Oil temp sens
- Overdrive switch (on floor console)
- Park/neutral position switch (on transaxle at linkage)
- Pin #10
- Pin #11
- Pin #6
- Power
- Power/economy change-over switch (on floor console)
- Press ctrl sol
- Pulse gen a
- Pulse gen b
- Pulse generators (right side of engine on transaxle)
- Pwr (backup)
- Pwr mode sig
- R n
- Red
- Reed switch (vss)(inst clstr)
- Rheostat
- Sens gnd
- Shift control solenoid valves
- Sol vlv a
- Sol vlv b
- Starter motor
- Switch
- Tcc sol
- Throt pos sens
- Throttle position sensor
- Torque converter clutch solenoid valve
- Turbo
- Unit pin #9
- Veh spd reed sw
- W/ auto- cruise
- W/o auto-
- W/o auto- cruise