TRANSMISSION – Suzuki SX4 Crossover 2008 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

4WD Wiring Diagram for Suzuki SX4 Crossover 2008

List of elements for 4WD Wiring Diagram for Suzuki SX4 Crossover 2008:

• (behind right kick panel) g11
• (under front passenger's seat) g16
• 2wd/4wd switch
• 4wd
• 4wd auto ind
• 4wd control module (center of dash)
• 4wd fuse 15a
• Back fuse 10a
• Can
• Combination meter
• Computer data lines system
• Coupling air temperature sensor (right rear of vehicle chassis)
• Coupling solenoid (right rear of vehicle chassis)
• G271
• G272
• Hard
• Hot at all times
• Hot in on or start
• Interior lights system
• J/b assembly (left side of dash)
• J/c g306
• J/c g309
• J/c l348
• Led output driver stepper motor &
• Micro controller
• Mtr fuse 10a
• Red
• Regulator voltage

A/T Wiring Diagram for Suzuki SX4 Crossover 2008

List of elements for A/T Wiring Diagram for Suzuki SX4 Crossover 2008:

• (behind right kick panel) g11
• (right side of engine) g4
• (under front passenger's seat) g16
• A/t fluid temperature sensor
• A/t relay (left side of engine compt)
• A/t select switch
• A/t shift lever assembly
• At fuse 15a
• Back fuse 10a
• C06
• C07
• Can
• Combination meter
• Computer data lines system
• Dome fuse 15a
• E323
• E325
• Exterior lights system
• G271
• G4 (right side of engine)
• G9 (at right front strut tower)
• Hot at all times
• Hot in on or start
• Ig1 sig fuse 10a
• Individual circuit fuse box 1
• Input shaft speed sensor (top of transaxle assembly)
• J/c g308
• J/c l348
• Junction block assembly (left side of dash)
• Lock up solenoid
• Micro controller
• Mtr fuse 10a
• Nca
• Off
• Output shaft speed sensor (top of transaxle assembly)
• P r
• Pressure control solenoid
• Red
• Regulator voltage
• Shift interlock system
• Shift solenoid
• Shift solenoid (on transaxle assembly)
• Starting/charging system
• Stepper motor & led output driver
• Tcm (right side of dash)
• Transaxle range sensor (on transaxle assembly)