INSTRUMENT CLUSTER – Chevrolet Malibu Classic LT 2008 – SYSTEM WIRING DIAGRAMS

INSTRUMENT CLUSTER

Instrument Cluster Wiring Diagram for Chevrolet Malibu Classic LT 2008

List of elements for Instrument Cluster Wiring Diagram for Chevrolet Malibu Classic LT 2008:

• (bcm)
• (center console, front of body control module) g201
• (ebcm)
• (ecm/bcm)
• (ecm/pcm)
• (or 33)
• (sdm)
• 2.2l
• 3.5l
• Abs ind
• Acc
• Air bag ind
• B10
• Battery
• Body control module (bcm) (under front of center console)
• Brake fluid level
• Brake fluid level switch (on brake master cylinder reservoir)
• Brake ind
• Charging ind
• Chime
• Cluster/ theft fuse 10a
• Computer data lines system
• Cruise ind
• Display
• Ect sens
• Engine control module (ecm) (left side of engine compt, forward of battery)
• Engine coolant temp ind
• Engine coolant temperature (ect) sensor (2.2l: on top rear of engine) (3.5l: on right cylinder head, above transmission)
• Engine coolant temperature gauge
• Engine oil pressure (eop) sensor (3.5l)
• Engine oil pressure switch (2.2l) (on rear left side of engine)
• Fuel level
• Fuel level gauge
• Fuel pump & sender assembly (under rear of vehicle, in fuel tank)
• G109 (near wind- shield wiper fluid reservoir)
• Ground
• High beam ind
• Hot at all times
• Ignition
• Ignition (run/ start)
• Ignition switch
• Illumination
• Instrument panel cluster (ipc)
• Interior lights system
• Left turn ind
• Logic
• Low engine oil pressure ind
• Low ref
• Low speed gmlan serial data
• Low traction ind
• Malfunction ind lamp
• Mil ctrl
• Off
• Oil press
• Park brake switch
• Park brake switch (on park brake assembly)
• Pnk
• Power distribution system
• Radio
• Right turn ind
• Run
• Seat belt ind
• Security ind
• Security ind signal
• Serial bus
• Serial data
• Serial data+
• Serial data-
• Service vehicle soon ind
• Speedometer
• Start
• Tachometer
• Tan
• Traction off ind
• Trip reset
• Trip reset switch