CRUISE CONTROL – Ford Contour SE 1997 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Contour SE 1997

List of elements for Cruise Control Wiring Diagram for Ford Contour SE 1997:

• 29s
• A/t
• Battery
• Brake on/off switch (top of brake pedal support)
• Brake pedal switch (top of brake pedal support)
• C136
• C201
• C221
• Clock- spring assembly
• Clutch pedal position switch (top of clutch pedal)
• Coast
• Deactivation in
• Engine compartment fuse box
• Exterior lights system
• Fuse 15a
• Fuse 7.5a
• G111 (battery support)
• Ground
• Horn
• Horn relay
• Hot at all times
• Hot in acc or run
• Hot in run
• Ignition
• Interior fuse panel
• M/t
• Nca
• Off
• Park/neutral position (pnp) switch (top of trans)
• Power distribution system
• Remote entry module (under right side of i/p)
• Resume
• S204 (fuse box harn, near safety wall harn, in breakout to 8 pin inline connector, above interior fuse panel)
• S205
• Set/accel
• Speed control cutout relay (left side of i/p)
• Speed control module (left rear corner of engine compt)
• Speed control/horn switch
• Switch in
• Switch return
• Traction control disable switch
• Vehicle speed sensor (lower rear of transaxle)
• Vss in
• W/ drl
• W/ remote entry only
• W/ traction control only
• W/o drl
• W/o traction control
• W/traction control