SUPPLEMENTAL RESTRAINTS
Supplemental Restraints Wiring Diagram for Ford RV Cutaway E350 Super Duty 2000
https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html
Automotive Electricians Portal FZCO
Automotive Electricians Portal FZCO 모든 배선 다이어그램에 액세스하십시오.List of elements for Supplemental Restraints Wiring Diagram for Ford RV Cutaway E350 Super Duty 2000:
- (lower dash harness, in breakout to data link connector (dlc)) s228
- (lower dash harness, near breakout to blend door actuator) s265
- (lower dash harness, near breakout to ground, below left side of dash, near kick panel)
- (main wiring harness, near breakout to 14 pin in-line connector, behind right kick panel)
- (main wiring harness, near breakout to ground under right side of dash) s267
- (main wiring harness, near breakout to instrument cluster) s275
- 4-wheel anti-lock brakes (4wabs) module (on left front frame rail)
- Air bag bracket
- Air bag bracket c210 (right side of dash, near air bag)
- Air bag ind
- Air bag indicator
- Air bag sliding contact
- Breakout to brake pedal position (bpp) switch) s221
- C226
- C341
- C342
- Center air bag sensor (front center of engine compartment, behind grille)
- Center sensor
- Central junction box (left side of dash, near kick panel)
- Data link connector (dlc) (partial) (below left side of dash)
- Datalink conn
- Driver safety belt
- Driver's air bag
- Drivers air bag
- Electronic crash sensor (ecs) module (behind right side of dash)
- Fuse 10a
- Fuse 15a
- Fuse 5a
- G201 (under right side of dash)
- G202 (below left side of dash, near kick panel)
- Ground
- Hot at all times
- Hot in run
- Hot in run or start
- If equipped
- Instrument cluster
- Lamp/warn buz
- Left courtesy lamp switch (mounted in left door jamb)
- Nca
- Pass air bag
- Passenger safety belt
- Passenger's air bag
- Pnk
- Power (bat)
- Preten feed
- Preten return
- Pretensioner feed
- Pretensioner nca
- Pretensioner return
- Pwr (run)
- Red/ pnk
- Red/pnk
- Return
- S201
- S233
- Shorting bar
- Shorting bar engaged when module connector is disconnected (shorting bars are connected between following pins: 1-15, 7-21, 14-28)
- Timer
- Warning buzzer module (behind center of dash)