INSTRUMENT CLUSTER – Hyundai Tiburon 2003 – SYSTEM WIRING DIAGRAMS

INSTRUMENT CLUSTER

Instrument Cluster Wiring Diagram (1 of 2) for Hyundai Tiburon 2003

List of elements for Instrument Cluster Wiring Diagram (1 of 2) for Hyundai Tiburon 2003:

• (behind center of dash) g11
• (behind left side of dash) g14
• 5v regulator
• 7v regulator
• Abs indicator
• Anti-lock brakes system
• Anti-theft system
• Bcm-im
• Bcm-jm
• Bcm-km
• Body control module box (behind left side of dash)
• Brake indicator
• Charge indicator
• Cruise control system
• Cruise indicator
• Door ajar
• Door ajar indicator
• Engine controls system
• Exterior lights system
• Fuel gauge
• Fuel gauge ground
• Fuel sender
• Fuse 10a
• G13 (behind left side of dash)
• Headlights system
• High beam indicator
• Hot at all times
• Hot in acc or on
• Hot in on or start
• Illumination indicator (4 bulbs)
• Immobilizer indicator
• Injector time input
• Instrument cluster
• Interior lights system
• Lcd led
• Left turn indicator
• Low fuel indicator
• Low fuel warning
• M10-1
• M10-2
• M10-3
• Micom
• Mil (check engine) indicator
• Odo trip switch
• Oil pressure indicator
• On/start input
• Over speed gnd
• Pnk
• Red
• Right turn ind
• Seat belt indicator
• Speedometer
• Srs indicator
• Starting/charging system
• Tachometer
• Tailgate open switch
• Tcs indicator
• Tcs off indicator
• Transmissions system
• Trip computer (lcd)
• Trip/c switch
• Trunk ajar indicator
• Vehicle speed input
• Warning system
• Water tempe- rature gauge
• Water temperature gauge

Instrument Cluster Wiring Diagram (2 of 2) for Hyundai Tiburon 2003

List of elements for Instrument Cluster Wiring Diagram (2 of 2) for Hyundai Tiburon 2003:

• (2.0l)
• (2.7l)
• Acc/on input
• Brake fluid level sensor (in brake fluid reservoir)
• C133-2
• C133-4
• C33
• Digital clock
• Diode z01 (behind center of dash)
• Drl control module (on left front inner fender panel)
• Empty
• Engine control module (behind right side of dash, above kick panel)
• Engine coolant temperature sensor & sender (2.0l: on rear of engine, near coolant outlet) (2.7l: on top left rear of cylinder head, near coolant outlet)
• Fuel level float
• Fuel sender
• Fuel sender & fuel pump motor (below center of rear seat)
• Full
• G11 (behind center of dash)
• G13 (behind left side of dash)
• G20 (on left side of engine compartment)
• G23 (behind left side of dash)
• Gauge sender
• Ground
• Injection signal
• Joint connector m35 (behind left side of dash)
• Joint connector m36 (behind left side of dash)
• Memory power
• Multi gauge circuit
• Nca
• Oil pressure switch (2.0l: upper rear of engine) (2.7l: lower left front of engine)
• Parking brake switch (on base of parking brake lever)
• Red
• Signal

Multi-Gauge Unit Wiring Diagram for Hyundai Tiburon 2003

List of elements for Multi-Gauge Unit Wiring Diagram for Hyundai Tiburon 2003:

• (2.0l w/ a/t) (2.0l w/ m/t) (2.7l)
• (2.0l) (2.7l)
• (behind right side of dash, above kick panel)
• 2.0l
• 2.7l
• Abs control module (in right front corner of engine compt)
• Bcm-im
• Bcm-jm
• Bcm-km
• Body control module box (behind left side of dash)
• C133-2
• C133-4
• C33
• Can interface canh
• Can interface canl
• Data link connector (below left side of dash)
• Engine control module
• Fuse 10a
• G11 (behind center of dash)
• Ground
• Hot at all times
• Hot in on or start
• Ill
• Injection signal input
• Instan- taneous fuel consump- tion gauge
• Instrument cluster
• Interior lights system
• Joint connector c41 c141 (behind left side of dash)
• Joint connector m34 (behind left side of dash)
• Joint connector m35 (behind left side of dash)
• Joint connector m36 (behind left side of dash)
• M10-1
• Memory power
• Multi gauge unit
• On/start input
• Red
• Speed sensor
• Torque gauge
• Transaxle control module (behind left side of dash)
• Vehicle speed sensor (on top of transaxle)
• Vehicle speed signal input
• Voltage gauge