CRUISE CONTROL – Chevrolet Colorado 2004 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Colorado 2004

List of elements for Cruise Control Wiring Diagram for Chevrolet Colorado 2004:

• 5 volt reference
• C204
• Class 2 serial data
• Cluster fuse 38 10a
• Clutch switch (on pedal assembly) (if equipped)
• Coast
• Computer data lines system
• Cpp switch signal
• Cruise control set/coast & resume/accelerate sw signal
• Cruise control switch
• Cruise fuse 19 10a
• Cruise indicator
• E11
• Electronic brake control module (on inner left frame rail)
• G105 (left side of engine compart)
• Hot at all times
• Hot in run or start
• Ignition
• Instrument panel cluster (ipc)
• Logic
• Low reference
• Pnk
• Powertrain control module (pcm) (right rear corner of engine)
• Resume/ accel
• Run/crank relay
• S100 (body harn, 14.5 cm from accelerator pedal position switch breakout)
• Set/
• Stop fuse 1 20a
• Stop lamp switch (top of brake pedal)
• Tac motor control-1
• Tac motor control-2
• Tan
• Tcc brake switch/cruise control release signal
• Tcc brake switch/cruise control release signal c1
• Tcc brake/ cruise release switch (above brake pedal assembly)
• Throttle actuator control (tac) motor
• Throttle body assembly
• Throttle position (tp) sens 1
• Throttle position (tp) sens 2
• Tp sensor 1 signal
• Tp sensor 2 signal
• Turn signal/multifunction switch
• Underhood fuse block (left front of engine compt)
• Vehicle speed sensor (vss) (on left rear transfer case)
• Vss high signal
• Vss low signal