Электросхемы СИСТЕМА КРУИЗКОНТРОЛЯ Isuzu i-280 S 2006

СИСТЕМА КРУИЗКОНТРОЛЯ

Электросхема системы круизконтроля для Isuzu i-280 S 2006

Электросхема системы круизконтроля для Isuzu i-280 S 2006 - Список элементов:

• 5 volt reference
• A/t
• A11
• Accelerator pedal position sensor (on accelerator bracket)
• Accy voltage
• App sensor 1 signal
• App sensor 2 signal
• B11
• Battery pos voltage
• Body control module (behind right kick panel)
• Class 2 serial data
• Cluster fuse 38 10a
• Clutch switch (top of clutch pedal assembly)
• Coast
• Computer data lines system
• Control release signal
• Cpp switch signal
• Cruise control set/coast &
• Cruise control switch
• Cruise fuse 19 10a
• Cruise indicator
• Cruise on/off
• E11
• G102 (at bottom left side of engine)
• G103 (bottom left side of engine)
• Ground
• Hot at all times
• Hot in run or start
• Ignition 1 voltage
• Instrument panel cluster (ipc)
• Logic
• Low reference
• M/t
• Pcm 1 fuse 25 10a
• Pcm b fuse 30 10a
• Pnk
• Power distribution system
• Powertrain control module (pcm) (right rear corner of engine compt)
• Resume/ accel
• Resume/accelerate sw signal
• Set/
• Stop fuse 1 20a
• Stop lamp switch (above brake pedal assembly)
• Tac motor control-1
• Tac motor control-2
• Tan
• Tcc brake switch/cruise
• Tcc brake/cruise release switch (above brake pedal assembly)
• Throttle actuator control (tac) motor
• Throttle body
• Throttle position (tp) sens 1
• Throttle position (tp) sens 2
• Tp sensor 1 signal
• Tp sensor 2 signal
• Turn signal/multifunction switch
• Underhood fuse block (left side of engine compt)
• Underhood fuse block (on left side of engine compartment)