СИСТЕМА КРУИЗКОНТРОЛЯ
Электросхема системы круизконтроля для Isuzu Rodeo LS 2002
Электросхема системы круизконтроля для Isuzu Rodeo LS 2002 - Список элементов:
- (left side of intake manifold)
- A/t mode switch (left side of trans)
- Acceleration position sensor assembly (above accelerator pedal)
- Acceleration sensors
- Anti-lock brakes & transmission systems
- Ap sen1 gnd
- Ap sen2 gnd
- Ap sensor 1
- Ap sensor 2
- Ap sensor 3
- Aps3 gnd
- Brake sw in
- Brake switch (on brake pedal support)
- C-16 (left rear corner of engine compt, on inner fender panel)
- Cancel
- Cb-11 meter fuse 15a
- Cb-12 engine ig fuse 15a
- Cb-14 back-up/ turn light fuse 15a
- Cb-6 stop light fuse 15a
- Clutch switch (on clutch pedal support)
- Cruise brake
- Cruise control main switch
- Cruise control res/acc switch
- Cruise lmp
- Cruise set light
- Cruise sw
- Dash fuse box (behind dash, left of steering column)
- Drive input
- E-21
- E-22
- E-28
- E-28 (left side of intake manifold)
- E-30 (right side of intake manifold)
- Eb-17 ecm fuse 30a
- Ecm or pcm main relay (in fuse/ relay box)
- Engine or powertrain control module (left rear of engine compartment)
- Fuse/ relay box (right side of engine compt)
- Gnd
- Hot at all times
- Hot in on or start
- I-9
- Ign feed
- Illum
- Interior lights
- Meter assembly
- On ind
- On switch
- Red
- Ref volt
- Res/acc in
- Set/cst
- Th val mtr
- Throttle position sensor 1
- Throttle position sensor 2
- Throttle val
- Throttle valve assembly (on throttle body assembly)
- Throttle valve motor
- Tps 1 sign
- Tps1 gnd
- Tps2 gnd
- Tps2 sign
- Vehicle speed sensor (rear of transmission)
- Vss in