СИСТЕМА КРУИЗКОНТРОЛЯ
Электросхема системы круизконтроля для Isuzu Rodeo LSE 2000
Электросхема системы круизконтроля для Isuzu Rodeo LSE 2000 - Список элементов:
- (right rear of engine)
- A/t gear position switch (left side of trans)
- Acceleration position sensor assembly (on accel pedal bracket)
- Acceleration sensors
- Ap sen1 gnd
- Ap sen2 gnd
- Ap sensor 1
- Ap sensor 2
- Ap sensor 3
- Aps3 gnd
- Brake sw in
- Brake switch (on brake pedal support)
- Cancel
- Cb-11 meter fuse 15a
- Cb-14 back-up/ turn light fuse 15a
- Cb-6 stop light fuse 15a
- Clutch switch (on clutch pedal support)
- Cruise brake
- Cruise control main switch
- Cruise control res/acc switch
- Cruise lmp
- Cruise set light
- Cruise sw
- Dash fuse box (behind dash, left of steering column)
- Drive input
- E-21
- E-22
- Eb-17 ecm fuse 30a
- Engine fuse 12 15a
- Engine or powertrain control module (2001 3.2l: left rear of engine compartment) (2000, 2001 2.2l: below center of dash)
- Exterior lights
- Fuse/ relay box (right side of engine compt)
- G111 (right side of engine compt behind battery)
- G117
- G117 (right rear of engine)
- G120 (right side of intake manifold)
- Gauge assembly
- Gnd
- Hot at all times
- Hot in on or start
- I-9
- Ign feed
- Illum
- Interior lights
- On ind
- On switch
- Pcm main relay (in fuse/ relay box)
- Red
- Ref volt
- Res/acc in
- Set/cst
- Th val mtr
- Throttle position sensor 1
- Throttle position sensor 2
- Throttle val
- Throttle valve assembly (on throttle body assembly)
- Throttle valve motor
- Tps 1 sign
- Tps1 gnd
- Tps2 gnd
- Tps2 sign
- Vehicle speed sensor (rear of transmission)
- Vss in