СИСТЕМА КРУИЗКОНТРОЛЯ
3.2L
3.2L, Электросхема системы круизконтроля для Isuzu Rodeo S 1998
3.2L, Электросхема системы круизконтроля для Isuzu Rodeo S 1998 - Список элементов:
- (a/t)
- (below center console) g302
- (m/t)
- A/t
- A/t gear position switch (beneath center of vehicle, on left side of transmission)
- A10
- A11
- A12
- A13
- Actuator control
- Actuator rel input
- B26
- Brake switch (behind dash, on brake pedal support)
- Brake switch input
- C23
- Cancel
- Cancel input
- Clutch switch (on clutch pedal support)
- Combination switch
- Cruise "on" indicator
- Cruise control actuator (on right side of engine compartment, on inner fender panel)
- Cruise control main switch
- Cruise control main switch light
- Cruise control switch
- Cruise control unit (under rear of center console)
- Cruise on input
- Cruise set indicator light
- Dash fuse box (behind dash, left of steering column)
- Drive input
- Engine control module (ecm) or powertrain control module (pcm) (below center of dash)
- F10
- Fuse 11 meter 15a
- Fuse 14 back up/ turn light 15a
- Fuse 15 elec. ign. 15a
- Fuse 6 stop light 15a
- Gauge assembly
- Ground
- Honda
- Hot at all times
- Hot in on
- Hot in on or start
- I-1
- I-2
- I-9
- Ignition
- Indicator control
- Interior lights system
- Isuzu
- M/t
- Off
- On input
- Red
- Res/ acc
- Resume/accel input
- Set coast
- Set/coast input
- Speedometer
- Vehicle speed sensor (vss) (beneath center of vehicle, rear of transmission)
- Vss input