SUPPLEMENTAL RESTRAINTS – Pontiac Bonneville SE 1999 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Pontiac Bonneville SE 1999

List of elements for Supplemental Restraint Wiring Diagram for Pontiac Bonneville SE 1999:

• (body harn, near tan
• (buick w/u23)
• (buick w/ub3)
• (pont w/ ub3) (olds)
• (pont w/0 ub3) a6 b12 a11 d7 c1
• (under left side of dash) data link connector (dlc)
• Air bag fuse 1c 10a
• Air bag ind
• Bar
• Body control module (mall) (behind right side of dash, near rear of glove box)
• Computer data lines system
• Dlc) s226
• Driver high
• Driver low
• G200 (left kick panel)
• G301 (under right front seat)
• Ground
• Hot in run, bulb test or start
• I/p fuse block (behind left side of dash)
• Ign
• Ign pos volt
• Indicator lamp
• Inflatable restraint front end discriminating sensor (sdm) (on radiator top support bracket)
• Inflatable restraint i/p module (top right of dash)
• Inflatable restraint sensing and diagnostic module (below right front seat)
• Inflatable restraint steering wheel module (on steering wheel)
• Inflatable restraint steering wheel module coil
• Instrument cluster (except buick w/ ub3) remote indicator bank (buick w/ ub3)
• Nca
• Passenger high
• Passenger low
• S225 (body harn, 50 cm from top edge of left kick panel)
• S309 (body harn, near ground g203 at right kick panel)
• Seat belt sw
• Seat belt switch
• Sensor input
• Serial data line
• Shorting
• Shorting bar
• Tan