WARNING SYSTEMS – Chevrolet Malibu LT 2008 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Chevrolet Malibu LT 2008

List of elements for Warning Systems Wiring Diagram for Chevrolet Malibu LT 2008:

• (under center console)
• Abs ind
• Air bag ind
• Ajar
• Auto
• Body control module (bcm) (under right side of center console)
• Brake fluid level switch (on brake master cylinder reservoir)
• Brake fluid lvl sw
• Brake ind
• Charge ind
• Computer data lines system
• Driver door latch (in driver door)
• Driver information center (dic)
• Driver seat belt switch
• Engine coolant temp ind
• G109 (on left rear core support, next to g104)
• G201 (under center console, on right side of front support bracket, next to g203, near bcm)
• G301 (under right rear seat back)
• Ground distribution system
• Head
• Hot at all times
• Ign sensor fuse 2a
• Ignition switch
• Inflatable restraint sensing & diagnostic module (sdm)
• Instrument panel cluster (ipc)
• Key in ignition switch
• Left
• Left rear door latch (in left rear door)
• Left seat belt sw
• Left turn ind
• Lf dr ajar sw sig
• Logic
• Low engine oil pressure ind
• Low ref
• Low spd gmlan serial data
• Low spd gmlan serial data bus
• Low speed gmlan serial data
• Lr dr ajar sw sig
• Lt trn sig sw
• Off
• Off/run/ crank voltage
• Park
• Park brake sw sig
• Park brake switch (on park brake assembly)
• Park lp sw sig
• Passenger door latch (in passenger door)
• Pnk
• Radio
• Rf dr ajar sw sig
• Right
• Right rear door latch (in right rear door)
• Right turn ind
• Rr dr ajar sw sig
• Rt trn sig sw
• Seat belt ind
• Serial data bus
• Service vehicle soon ind
• Turn signal/ multifunction switch