TRANSMISSION
Transmission Wiring Diagram for Hyundai Scoupe LS 1995
List of elements for Transmission Wiring Diagram for Hyundai Scoupe LS 1995:
- (above accelerator) accelerator pedal switch
- (lower left front of engine, on top of transaxle)
- (lower left side of engine, in top of transaxle)
- 2 input
- A/c sw input
- Accl sw input
- Air conditioning system
- Battery
- C01
- Damper clutch solenoid valve
- Dash fuse box
- Data link connector
- Diag output
- Drive input
- Econ mode
- Ect switch
- Eng rpm input
- Engine control module (left i/p)
- Engine controls system
- Exterior lights system
- Fuse 10a
- G111 (near battery)
- G200 (left kick panel)
- G202 (left side of i/p)
- Ground
- Hi oil temp
- High temp
- Hot at all times
- Hot in on
- I05-1
- I05-3
- I06
- Ignition
- Instrument cluster
- Kick down switch (center front of transaxle)
- Kickdn sw
- L input
- Lo oil temp
- Low temp
- M02
- M07-1
- M07-2
- M07-3
- N/a
- Nca
- Neutral input
- O/d off
- O/d off indicator
- O/d on
- O/d sw input
- Oil pressure control solenoid valve
- Overdrive switch
- Park input
- Pulse gen a
- Pulse gen b
- Pulse generator a
- Pulse generator b
- Red
- Reverse input
- Rsw
- Sensor gnd
- Shift control solenoid valve a
- Shift control solenoid valve b
- Signal eng speed
- Sol vlv ctrl
- Starting/ charging system
- Tps input
- Tps output
- Transaxle oil temperature sensor (in left front corner of transaxle)
- Transaxle range switch
- Transaxle valve body
- Transmission control module (below left front seat)
- Veh spd input
- Vehicle speed sensor