CRUISE CONTROL
Cruise Control Wiring Diagram for Chrysler PT Cruiser GT 2006
List of elements for Cruise Control Wiring Diagram for Chrysler PT Cruiser GT 2006:
- (a/t)
- (m/t)
- (near breakout for camshaft position sensor)
- A931
- C11
- Clutch interlock switch (m/t) (left side of dash)
- D15
- D16
- D20
- D21
- Data link connector (under left side of dash, near kick panel)
- Dump
- F855
- Fuse 10a
- Fused b(+)
- G105 (left front inner fender)
- Hot at all times
- Input speed sens sig
- Input speed sensor (a/t) (on left side of transaxle)
- Interlock switch sig
- K75
- K914
- Output speed sens sig
- Output speed sensor (a/t) (on left side of transaxle)
- Powertrain control module (on firewall, behind power distribution center)
- Red
- S/c sw 1 sig
- S/c sw rtn
- S109
- S128 (right front of engine compartment)
- Sci receive
- Sci receive (tcm)
- Sci transmit
- Sci transmit (tcm)
- Sensor gnd
- Sensor ground
- Sensor sig
- Speed control servo (2.4l) (at right rear corner of engine compt)
- Speed control switch
- Speed sig
- Speed signal
- Speed sw sig
- Steering control module (left side of dash)
- Stop lamp switch (left side of dash)
- T14
- T141
- T41
- T52
- Totally integrated power module
- Transmission range sensor (a/t) (in transaxle, on top of valve body)
- Trs t41 sns
- V32
- V35
- V36
- V71
- Vacuum
- Vacuum sol
- Vehicle speed sensor (m/t) (on transaxle)
- Vent
- Vent sol