ANTI-LOCK BRAKES – Dodge Dakota 1995 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

All-Wheel ABS Wiring Diagram for Dodge Dakota 1995

List of elements for All-Wheel ABS Wiring Diagram for Dodge Dakota 1995:

• (left fender side shield)
• 3.9 & 5.2l only
• 4-wheel drive input
• A20
• Abs control module (all-wheel abs) (left fender side shield)
• Abs power relay (in power distribution center)
• Abs warning ind
• Abs warning ind check
• Abs warning ind relay
• Abs warning lamp relay (in power distribution center)
• Acc
• B/h conn
• B/h conn (pin #41)
• B/h conn pin #40
• B113
• B114
• B116
• B120
• B18
• B19
• B243
• B245
• B248
• B249
• B252
• B254
• B47
• B60
• Brake ind
• Brake sense
• Brake warning ind
• Brake warning lamp switch (in hydraulic unit)
• C118
• C119
• C221
• Case ground
• D11
• D12
• Data link connector (right cowl)
• Data link input
• Data link output
• Dump sol
• Four wheel drive indicator switch (on transfer case)
• Front hydraulic valve (on left front fender shield)
• Fuse & relay block: i/p
• Fuse 5a
• Fuse a 40a
• Fuse f2 5a
• G100 (left fender side shield)
• G102
• G107
• G125 (below a/c compressor)
• G19
• G206 (left of radio)
• Hot at all times
• Hot in run
• Ignition feed
• Ignition switch
• Instrument cluster
• Instrument cluster system (4wd ind lamp in shift bezel) (pin #6)
• Isolate sol
• Left dump and isolation solenoids
• Left front reset
• Left front sensor high
• Left front sensor low
• Left front wheel sensor
• Lt frnt dump valve ctrl
• Lt ft isolate valve ctrl
• Motor feedback
• Nca
• Off
• Park brake switch (on park brake)
• Pin #14
• Pin #16
• Pin #28
• Pin #34
• Pin #39
• Pnk
• Power distri- bution center
• Power distribution center
• Power ground
• Power relay enable
• Pump motor return
• Rear dump valve ctrl
• Rear hydraulic valve (near master cylinder)
• Rear isolate valve ctrl
• Rear reset
• Rear sensor high
• Rear sensor low
• Rear wheel speed sensor (top of rear differential)
• Red
• Reset sw
• Right dump and isolation solenoids
• Right front reset
• Right front sensor high
• Right front sensor low
• Right front wheel sensor
• Rt frnt dump valve ctrl
• Rt ft isolate valve ctrl
• Run
• Start
• Stop lamp & cruise control switch (on brake pedal) bracket) (w/ cruise control)
• Stop lamp switch (on brake pedal w/o cruise control)
• Time delay relay (i/p fuse & relay block)
• To engine controls system (pcm ii pin #29)
• V40

Rear Wheel ABS Wiring Diagram for Dodge Dakota 1995

List of elements for Rear Wheel ABS Wiring Diagram for Dodge Dakota 1995:

• (stop lamp switch w/o cruise control)
• 4-wheel drive input
• Abs warning ind
• Abs warning ind ctrl
• Acc
• B/h conn pin #40
• B101
• B102
• B108
• B111
• B112
• B113
• B114
• Battery
• Brake sense
• Brake sw input
• Brake warning lamp switch (on left frame rail)
• Bulb check
• C221
• Combination buzzer
• Data link conn (right side of i/p)
• Diode (taped in i/p harness)
• Dual solenoid hydraulic valve (near master cylinder)
• Dump sol
• Dump valve sol
• Exterior lights system (center mounted stop lamp)
• Exterior lights system (hazard flasher switch)
• F32
• Four wheel drive indicator switch (on transfer case)
• Fuse & relay block: (i/p
• Fuse & relay block: i/p
• Fuse 10a
• Fuse 20a
• G100 (left fender side shield)
• G104 (left inner fender panel)
• G11
• G125 (below a/c compressor)
• G206 (left of radio)
• Ground
• Hot at all times
• Hot in run or start
• Ignition
• Ignition switch
• Instrument cluster
• Instrument cluster system (4wd ind lamp in shift bezel) (pin #6)
• Intermittent wiper control unit (under steering column)
• Isolate sol
• Nca
• Off
• Park brake ind
• Park brake input
• Park brake switch (on park brake)
• Powertrain control module (center of dash panel)
• Rear isolate valve sol
• Rear wheel anti-lock control module (under right side of i/p)
• Rear wheel anti-lock sensor (top of rear axle)
• Reset
• Reset sw
• Rolls test conn (right side of steering column)
• Run
• Rwal sensor
• Service data link
• Start
• Stop lamp & cruise control switch (on brake pedal bracket)
• V40