CRUISE CONTROL
Cruise Control Wiring Diagram for Dodge Dakota 2003
List of elements for Cruise Control Wiring Diagram for Dodge Dakota 2003:
- (3.9l: rear of engine) (5.9l/4.7l: left rear of engine) s103
- (in engine compt, on right inner fender panel) powertrain control module
- (on right fender side shield) g112
- (right front of engine compt) vehicle speed control servo
- 3.9l/5.9l
- 4.7l
- Accel/ resume
- Brake lamp switch (on brake pedal bracket)
- Cancel
- Clockspring (top of steering column, below steering wheel)
- Coast
- Cruise control lamp control
- Cruise indicator
- D25
- Data link connector (under dash, left of steering column)
- Dump
- Fuse 10a
- Fused ign
- Hot in run or start
- Instrument cluster
- Joint connector 3 (in pdc)
- Junction block (left end of dash)
- Left speed control switch
- Nca
- On/off
- Pci bus
- Right speed control switch
- S201 (behind left side of dash)
- S202 (behind right side of dash)
- Sensor gnd
- Set
- Speed sw sig
- Tan/red
- V32
- V35
- V36
- V37
- Vacuum
- Vacuum sol
- Vent
- Vent sol