CRUISE CONTROL – Cadillac ELR 2014 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram (1 of 2) for Cadillac ELR 2014

List of elements for Cruise Control Wiring Diagram (1 of 2) for Cadillac ELR 2014:

• (lower right rear of engine) g113
• 12 volt ref
• Acc fuse 10a
• App 5 volt ref 1
• App 5v ref 2
• App low ref 1
• App low ref 2
• App sig 1
• App sig 2
• Automatic transmission assembly (left side of drive motor/transmission assembly)
• Body control module (bcm) (right side of dash)
• Computer data lines system
• Control solenoid valve assembly
• Cruise ctrl sw sig
• Cruise ind
• Cruise sw sig
• Cruise/etc/tcc brake signal
• Ecm fuse 5a
• Engine control module (ecm) (behind left end of front fascia)
• Gnd
• Hot at all times
• Instrument cluster
• Lo spd gmlan serial data
• Logic
• Network bus
• Red
• Serial data (+)
• Serial data (-)
• Steering wheel air bag coil (top of steering column)
• Switch signal
• Tac ctrl close
• Tac ctrl open
• Tp sens sig 2
• Tp sensor sig 1
• Tps 5v ref
• Tps lo ref
• Transmission control module
• Transmission output shaft speed sensor
• Underhood fuse block (left side of engine compt)
• X150

Cruise Control Wiring Diagram (2 of 2) for Cadillac ELR 2014

List of elements for Cruise Control Wiring Diagram (2 of 2) for Cadillac ELR 2014:

• (behind center of front fascia) (if equipped) cruise control vehicle distance sensor module
• (right front of engine) throttle body
• Accelerator pedal position sensor (top of accelerator pedal assembly)
• Cancel switch
• Computer data lines system
• Cruise ind
• G102 (front of right frame rail)
• Gap switch
• Gnd
• Hi spd gmlan (+)
• Hi spd gmlan (-)
• Left steering wheel controls switch
• Res+
• Serial data communication enable
• Set-
• X190
• X225