CRUISE CONTROL – Cadillac Escalade ESV 2005 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Cadillac Escalade ESV 2005

List of elements for Cruise Control Wiring Diagram for Cadillac Escalade ESV 2005:

• 5v ref
• A10
• Acceleration pedal position sensor (behind accelerator pedal)
• App sensor 1 sig
• App sensor 2 sig
• Class 2 data
• Computer data lines system
• Cruise control on/off switch
• Cruise fuse 10a
• Cruise ind
• Cruise on sw sig
• Etc/ecm fuse 15a
• F12
• G104 (left rear of engine)
• Ground
• Hot at all times
• Hot in run
• Hot in run & start
• Ign
• Ign volt
• Instrument panel cluster
• Left i/p fuse block (on lower left side of dash)
• Low ref
• Nca
• Off
• Pnk
• Powertrain control module (left front of engine compt)
• Resume/ accel
• Resume/accel
• Resume/accel sig
• S102
• S240
• Serial data
• Set/ coast
• Set/coast sig
• Stop lps fuse 20a
• Stoplamp switch (top of brake pedal)
• Tac motor cntrl 1
• Tac motor cntrl 2
• Tan
• Throttle actuator control module (left rear of engine compt)
• Throttle body
• Tp sensor 1 sig
• Tp sensor 2 sig
• Turn signal multifunction switch
• Under- hood fuse block
• Underhood fuse block (near battery)
• Veh stop fuse 15a
• Vehicle speed sensor (vss) (on rear of transmission)
• Vss high
• Vss low
• W/ electronic adjustable pedal
• W/o electronic adjustable pedal