CRUISE CONTROL – GMC Envoy 2003 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

4.2L VIN S

4.2L VIN S, Cruise Control Wiring Diagram for GMC Envoy 2003

List of elements for 4.2L VIN S, Cruise Control Wiring Diagram for GMC Envoy 2003:

• 5 volt ref
• Accelerator pedal position sensor (above accelerator pedal, on bracket)
• App sensor 1
• App sensor 2
• B10
• B4 c1
• C9 c2
• Close
• Cruise release
• E3 c3
• Electronic brake control module (on inner left frame rail, beside transmission)
• Exterior lights system
• Hot at all times
• Hot in run
• Hot in run and start
• Hvac i fuse 39 10a
• Ign e fuse 22 10a
• Low ref
• On sw
• On/off switch
• Open
• Pnk
• Powertrain control module (on upper left side of engine)
• Rear fuse block (below left rear seat)
• Res/accel sw
• Res/accel switch
• Set/coast sw
• Set/coast switch
• St/lp fuse 12 25a
• Stop lamp input
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Tcc/brake switch (above brake pedal, on bracket)
• Throttle body (throttle actuator control motor)
• Tp sensor 1
• Tp sensor 2
• Turn signal/ multifunction switch
• Underhood fuse block (on left side of engine compartment)
• Veh stop fuse 34 15a
• Vehicle speed sensor (vss) (on left rear of transfer case)
• Vehicle speed sig
• Vss hi
• Vss lo