ELECTRONIC SUSPENSION – GMC Envoy 2003 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram for GMC Envoy 2003

List of elements for Electronic Suspension Wiring Diagram for GMC Envoy 2003:

• 4.2l
• 4wd fuse 15a
• 5.3l
• Air suspension compressor assembly (except xl: behind right rear wheelwell, on frame rail, xl : on left rear frame rail, near spare tire)
• Air suspension inflator switch (xl: on left side of cargo area, on trim panel, except xl: on right side of cargo area, on trim panel)
• B11
• Battery
• Control
• Ecas fuse 30a
• G305 (on outside of left frame rail, near fuel tank)
• Ground
• Hot at all times
• Hot in run
• Ign 3
• Instrument panel cluster
• Led signal
• Left rear air suspension sensor (on frame rail, near left rear suspension arm)
• On/off
• Powertrain control module (4.2l: near upper left side of eng, 5.3l: near lower left front of eng)
• Rear fuse block (below left rear seat)
• Red
• Right rear air suspension sensor (on frame rail, near right rear suspension arm)
• S117 (i/p harn, 8.5 cm from c100 breakout, toward underhood fuse block, c5 & c6 breakouts)
• S306
• Sensor ret
• Sensor sig
• Speed sens
• Tan
• Transmissions system
• Underhood fuse block (on left side of engine compt)