CRUISE CONTROL – GMC Safari 2000 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for GMC Safari 2000

List of elements for Cruise Control Wiring Diagram for GMC Safari 2000:

• (shown brakes off)
• 510 ohms
• A12
• A13
• A14
• A15
• Brake fuse 18 10a
• Brake pedal position switch (above brake pedal)
• Brake sw input
• Chmsl resistor (left kick panel)
• Cruise control module (center front of firewall)
• Cruise control switch
• Cruise engaged
• Cruise fuse 6 10a
• Cruise on/off input
• Cruise release sw
• Engine control system
• Exterior lights system
• G116 (left side of firewall, above battery)
• G125 (front of engine near thermostat housing)
• Ground
• Hot at all times
• Hot in run
• I/p fuse block (behind left side of dash)
• Ignition
• Nca
• Off
• R/a
• Resume/accel input
• S/c
• S117
• S130 (front of dash, 32 cm from forward lamp harness breakout)
• S200 (i/p harness, 16 cm from i/p fuse block breakout)
• S201
• S204
• S206
• S221
• Set/coast input
• Sound system
• Stop/haz fuse 1 20a
• Vehicle control module (vcm) (left side of engine compt)
• Vehicle speed sensor (vss) (rear of transmission)
• Vss high
• Vss low
• Vss signal