STARTING/CHARGING – GMC Safari 2000 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for GMC Safari 2000

List of elements for Charging Wiring Diagram for GMC Safari 2000:

• (in dash harness 41 cm (16.1 in) from headlamp switch connector) s213
• (in dash harness, right kick panel) s260
• (left side radiator support) g108
• (lower right side of engine block) g120
• (not used)
• 12v
• A12
• Battery
• Charge indicator
• Class 2
• Gauges fuse 4 10a
• Generator
• Hot at all times
• Hot in run & start
• I/p fuse block (behind left side of dash)
• Ign 1
• Instrument cluster
• L term generator control/monitor
• Pnk
• Power distribution system
• Radio batt fuse 19 10a
• Red
• S121
• Serial data class 2
• Solid state
• Splice pack sp261 (in dash harness 20 cm (7.9 in) from relay blocks breakout toward data link connector (dlc))
• Starter solenoid
• Vehicle control module (vcm) (left side of engine compartment)
• Voltage regulator

Starting Wiring Diagram for GMC Safari 2000

List of elements for Starting Wiring Diagram for GMC Safari 2000:

• (behind center of dash) g206
• (in engine harness 17 cm (6.7 in) from underhood fuse block breakout) s111
• (lower right side of engine block) g120
• (on left center of transmission) park/neutral position & back-up lamp switch
• Acc
• Batt
• Battery
• Bulb test
• Crank fuse 8 10a
• Fuse block breakout)
• Generator
• I/p fuse block (behind left side of dash)
• Ign-a maxi fuse 40a
• Ignition switch
• Lock
• Nca
• Off
• Red
• Run
• S108 (in engine harness 10.5 cm (4.1 in) from underhood red
• S121
• Start
• Starter enable relay
• Starter motor
• Starter solenoid
• Underhood fuse block (on left side of firewall)
• Upfitter battery power stud