STARTING/CHARGING – GMC Canyon 2011 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for GMC Canyon 2011

List of elements for Charging Wiring Diagram for GMC Canyon 2011:

• (right rear of engine compt) engine control module (ecm)
• A11
• B11
• Battery
• Charge ind
• Computer data lines system
• Driver information center (dic) display
• Field duty cyc
• G100 (next to rear side of battery)
• G102 (lower left side of engine)
• G104 (left side of engine)
• Gen reg cntrl
• Gen turn on
• Generator
• Generator battery control module (left front of engine compt, near battery)
• Gnd
• Ground
• Instrument panel cluster (ipc)
• J106
• Logic
• Mega fuse 125a
• Power distribution system
• Red
• Rvc fuse 10a
• Serial data
• Starter
• Underhood fuse block (left front side of engine compt)
• X10
• X11

Starting Wiring Diagram for GMC Canyon 2011

List of elements for Starting Wiring Diagram for GMC Canyon 2011:

• 5v ref
• A14
• A42
• A42 key resistor sig
• A47
• Acc
• Automatic transmission (a/t)
• B11
• Battery
• Body control module (bcm) (behind right kick panel)
• C11
• Clutch pedal position (cpp) sensor (m/t)
• Computer data lines system
• Cpp sig
• Engine control module (ecm) (right rear of engine compt)
• G100 (next to rear side of battery)
• G102 (lower left side of engine)
• G104 (left side of engine)
• Ign volt x2
• Ignition switch
• Internal mode switch
• J110 (a/t)
• Low ref
• Off
• Park/
• Red
• Run
• Serial
• Serial data
• Serial data x1
• Start
• Starter
• Strtr fuse 30a
• Strtr relay
• Underhood fuse block (left front side of engine compt)
• X1 ctrl rly
• X1 data
• X10
• X204
• X3 signal neutral