AIR CONDITIONING – Mitsubishi Raider LS 2008 – SYSTEM WIRING DIAGRAMS

AIR CONDITIONING

Manual A/C Wiring Diagram for Mitsubishi Raider LS 2008

List of elements for Manual A/C Wiring Diagram for Mitsubishi Raider LS 2008:

• (on right front of engine) a/c compressor clutch
• 87a
• A/c clutch relay
• A/c clutch rly ctrl
• A/c pressure transducer (at right front of engine compt)
• A/c-heater control
• Blend door actuator (on right side of hvac unit)
• Blend door drv
• Blower motor (on front of hvac unit)
• Blower motor high speed
• Blower motor low speed
• Blower motor m1 speed
• Blower motor m2 speed
• Blower motor relay
• Blower motor resistor block (on right side of hvac unit)
• Can (+)
• Can (-)
• Can b bus (+)
• Can b bus (-)
• Cluster
• Common door drv
• Computer data lines system
• Door drv
• Ect sig
• Engine coolant temperature sensor (on right front side of engine)
• Evap temp sens sig
• Evaporator temp sens sig
• Evaporator temperature sensor (on hvac unit)
• Fcm sens rtn
• Floor to defrost mode door actuator (on top of hvac unit)
• Floor to panel mode door actuator (on top of hvac unit)
• Front control module
• Fuse 11 10a
• Fuse 35 40a
• Fuse 59 10a
• Fuse 7 10a
• Fused ign sw out (run)
• G107 (at right side of engine compt)
• G200 (behind left side of dash)
• G201 (behind right side of dash)
• Ground
• Hot at all times
• Hot in run
• Ign sw out (run)
• Integrated power module (at left side of engine compt)
• Ipm
• Mode door 1 drv
• Mode door 2 drv
• Panel lamps drv
• Powertrain control module (at right side of engine compt)
• Pressure sig
• Recirculation
• Recirculation door actuator (on right side of hvac unit)
• Recirculation door drv
• Sens gnd
• Transmissions system